Rockwell-automation 1798-IE4 FlexArmor Analog Input Module Manual de usuario descargar pdf (Pagina 5)

FlexArmor Analog Input Module 5

Publication 1798-IN007A-EN-P - April 2002

4. Screw down the module retaining screws to ensure IP67

compliance.

Connect the Cordset to the FlexArmor Module

The module uses 5 pin micro (12mm) style PCB mounted connectors.

Four micro caps cover the I/O connectors on the module. Remove

the caps and connect your cables to the appropriate ports. Keep the

caps in place on any unused connector to maintain the IP67 rating.

A pinout diagram for the connectors is shown below.

IMPORTANT

• Torque the screws to 0.5-0.7 Nm. (4.43 - 6.2

inch pounds).

• Dust caps must have 4 inch pounds of torque

to maintain IP67 compliance.

ATTENTION

• Make sure all connectors and caps are

securely tightened to properly seal the

connections against leaks and maintain IP67

requirements.

• For maximum noise immunity, input and

output cable return wires must be properly

terminated. When inputs and outputs are

connected in loopback, return wires should

be connected together.

• I/O cable length should be less than 30

meters.

42652

Female Input Micro-Connector

(View into Socket)

Pin 1 Sensor Power

Pin 2 Current Input

Pin 3 Sensor Common

Pin 4 Voltage Input

Pin 5 Not Used

1 2 3 4 5 6 7 8

Sin comentarios

Rockwell-automation 1798-IE4 FlexArmor Analog Input Module Manual de usuario Pagina 5