Rockwell-automation 20P PowerFlex DC Drive - Frame A Pulse Transformer Manual de usuario descargar pdf (Pagina 2)

2 PowerFlex® DC Drive - Frame A Pulse Transformer Circuit Board

What You Need to Do

To install the Pulse Transformer board:

❐ Step 1: Remove power from the drive

❐ Step 2: Remove the protective covers

❐ Step 3: Remove the Control EMI shield and Control board

❐ Step 4: Remove the Pulse Transformer and Switching Power Supply

boards

❐ Step 5: Configure the new Pulse Transformer board

❐ Step 6: Install the new Pulse Transformer board and existing

Switching Power Supply board

❐ Step 7: Install the Control EMI Shield and Control board

❐ Step 8: Replace the protective covers and document the change

Step 1: Remove Power

from the Drive

1. Remove and lock-out all incoming power to the drive.

ATTENTION: Remove power before making or breaking cable

connections. When you remove or insert a cable connector with

power applied, an electrical arc may occur. An electrical arc can

cause personal injury or property damage by:

• sending an erroneous signal to your system’s field devices,

causing unintended machine motion

• causing an explosion in a hazardous environment

Electrical arcing causes excessive wear to contacts on both the

module and its mating connector. Worn contacts may create

electrical resistance.

L1 L2 L3

1 2 3 4 5 6 7 ... 19 20

Sin comentarios

Rockwell-automation 20P PowerFlex DC Drive - Frame A Pulse Transformer Manual de usuario Pagina 2