Rockwell-automation 20P PowerFlex DC Drive - Frame D Field Circuit Boa Manual de usuario descargar pdf

Publication 20P-IN051A-EN-P

PowerFlex® DC Drive

Frame D Field Circuit Board

Installation Instructions

What This Kit Includes

• Field circuit board

• Ribbon cable at connector XFCD

• Cable at connector X3

• Eleven hexalobular screws

• Static strap

Tools That You Need

• Phillips

screwdriver

• Hexalobular screwdriver

Phillips

is a registered trademark of Phillips Screw Company.

What You Need to Do

To install the field board:

❐ Step 1: Remove power from the drive

❐ Step 2: Remove the protective covers

❐ Step 3: Remove the existing field board

❐ Step 4: Install the new field board

❐ Step 5: Replace the protective covers and document the change

ATTENTION: Only qualified personnel familiar with DC drives

and associated machinery should plan or implement the installation,

start-up and subsequent maintenance of the system. Failure to comply

may result in personal injury and/or equipment damage.

ATTENTION: To avoid an electric shock hazard, ensure that all

power to the drive has been removed before performing the following.

ATTENTION: This drive contains ESD (Electrostatic Discharge)

sensitive parts and assemblies. Static control precautions are required

when installing, testing, servicing or repairing this assembly.

Component damage may result if ESD control procedures are not

followed. If you are not familiar with static control procedures,

reference A-B publication 8000-4.5.2, “Guarding Against

Electrostatic Damage” or any other applicable ESD protection

handbook.

1 2 3 4 5 6

Indice de contenidos

Pagina 1 - Installation Instructions

Publication 20P-IN051A-EN-PPowerFlex® DC DriveFrame D Field Circuit BoardInstallation InstructionsWhat This Kit Includes• Field circuit board• Ribbon

Pagina 2 - Protective Covers

Publication 20P-IN051A-EN-P2Step 1: Remove Power from the Drive1. Remove and lock-out all incoming power to the drive. Step 2: Remove the Protective C

Pagina 3 - Figure 1 Cover Removal

3Publication 20P-IN051A-EN-PFigure 1 Cover Removal 4. Disconnect the HIM communication cable from the connector on the upper right corner of the Con

Pagina 4 - Existing Field Board

Publication 20P-IN051A-EN-P4Step 3: Remove the Existing Field Board1. Loosen the eight hexalobular screws that secure the protective plastic cover to

Pagina 5 - Field Board

5Publication 20P-IN051A-EN-PImportant: Mark all connections and wires before removal to avoid incorrect wiring during reassembly.2. Disconnect the cab

Pagina 6 - Related Documentation