Rockwell-automation 21G PowerFlex 755 Transition Section and Splicing Manual de usuario descargar pdf (Pagina 20)

20 Rockwell Automation Publication 750-IN027C-EN-P - November 2013

PowerFlex 755 Transition Section and Splicing Kit for Floor-mount Drives and CENTERLINE 2100 Motor Control Centers

Step 7: Join Horizontal Bus and Splicing Bars

Splicing kits will contain either two or four sets of hardware per splice bar,

depending on the current rating of the horizontal bus. Assemble hardware as

depicted in Figure 2

and uniformly tighten splice kit hardware to the final torque

listed in Table 1

Figure 2 - Splicing Hardware Configuration Detail

See Tab le 3 for main horizontal bus-bar splicing bar dimensions.

IMPORTANT

Note for NO-OX-ID: If you’re using corrosion inhibitor on bus bars, do not get

any on the bus splicing hardware. It will prevent the hardware from being

properly torqued. Damage may occur.

Main Horizontal Bus -bar

Main Horizontal

Bus-bar Splicing Bars

Flat Washers

One-Piece Nut and Conical Spring Washer

Bus Clamps

Front

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Rockwell-automation 21G PowerFlex 755 Transition Section and Splicing Manual de usuario Pagina 20