Rockwell-automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL Manual de usuario descargar pdf (Pagina 10)

A–B

Chapter

3–1

Installing the Software

This chapter shows how to install the DL20 Offine Programming Software

on your computer.

You should have at least 448K of available RAM to run the DL20 Offline

Programming Software on your computer. Check the available RAM on

your computer using the DOS CHKDSK command.

As a safety precaution, it is recommended that you make at least one copy

of the DL20 Offline Programming Software and save the original disk as

a master.

The 5

and 3

inch installation disks are shipped from Allen-Bradley

with a write protect tab. You cannot write to the disk unless the write protect

tab is removed. However, you can make copies without removing the tab.

This section shows how to install the DL20 Programming Software on:

• Computer with 1 Hard drive and 1 Floppy or Micro disk drive

• Computer with 2 Floppy or Micro disk drives

• Computer with 1 Floppy or Micro disk drive

Refer to the appropriate section.

The software is provided on 5

and 3

inch disks. Use the size

appropriate for your computer.

Chapter Objectives

Checking

Available RAM

Making a Copy

of the Software

Installing

the

DL20

Programming Software

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 66 67

Sin comentarios

Rockwell-automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL Manual de usuario Pagina 10