Rockwell-automation 2711C-xxxx PanelView Component HMI Terminals Quick Manual de usuario descargar pdf (Pagina 21)

21Publication 2711C-QS001F-EN-P - November 2010 21

Chapter

2

Make Terminal Connections

Introduction

In this chapter, you will connect a PanelView Component C600 terminal to your computer, connect power,

get the IP address of terminal, and launch the PanelView Explorer software.

Before You Begin

Determine if the connection between the PanelView Component terminal and the computer will be through

the Ethernet port or the USB port of the terminal.

• PanelView Component C600 and C1000 terminals support an Ethernet connection using either the

USB port or the Ethernet port.

• All PanelView Component terminals support an Ethernet connection using the USB port. The C200

and C300 terminals support only a USB connection.

What You Need

• PanelView Component C600 terminal

• Computer with Windows 2000, Windows XP, or the Vista operating system, and Internet Explorer 7

browser or the Mozilla Firefox 2.0 or 3.0 browser. The Windows 2000 operating system supports only

the Ethernet connection.

• Standard Ethernet cable or 2711P-CBL-EX04 cable for Ethernet port connection

• 2711C-CBL-UU02 USB cable for USB port connection

Topic Page

Connect Terminal to Computer 23

Connect Power to Terminal 24

Get the IP Address of Terminal 25

Launch PanelView Explorer 26

Configure Browser Settings 27

IMPORTANT

The USB device port is for maintenance or programming only, and is not intended for normal

run-time operation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 109 110

Comentarios a estos manuales

Sin comentarios