Rockwell-automation 56AMXN ControlLogix/AutoMax/Communication/Module Manual de usuario descargar pdf (Pagina 13)

DCSNet/RE RIO Module 13

Publication 56AMXN-IN002A-EN-P November 2002

Wire the Connector for the AutoMax Network

Use a drop cable, 612574-36R, available through Rockwell Automation Systems

Business, and passive tap M/N 57C380 to connect the module to the coaxial

network cable. This cable turns down and has a ferrite to reduce EMI. This cable

must be used in CE applications. You can also use drop cable 612403-036R but it

points up.

The drop cable is a 3-foot long multi-conductor cable with 9-pin D-shell connectors

at each end. Connect one end to the connector on the module and the other end to

the passive tap.

The passive tap has two BNC connectors for connection to the coaxial cables and

terminating loads.

The network coaxial cable must be terminated with 75 ohm terminating loads

attached to the taps at the physical ends of the network. There should be two and

only two terminators on the network.

For DCS, the network cable can be RG-59/U or RG-11/U. For remote I/O, the

cable must be RG-59/U.

Apply Chassis Power

Turn the rack power supply on.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Rockwell-automation 56AMXN ControlLogix/AutoMax/Communication/Module Manual de usuario Pagina 13