Rockwell-automation 57C435 Processor Module, AutoMax Manual de usuario descargar pdf (Pagina 50)

EĆ2

1d Privilege violation detected

Ć runbase software fault

Ć bad Processor module

1E UnĆimplemented instruction detected

Ć runbase software fault

Ć bad Processor module

1F Illegal interrupt detected

Ć runbase software fault

Ć bad Processor module

30 Problem in application software

31 Bus error

Ć attempt to access invalid address

32 Define channel error

Ć problem in application software

33 Define scan error

Ć hardware fault

34 Memory integrity lost

Ć hardware fault

35 DC drive CML block initialization error

36 Communication between drive processor and I/O

controller lost

Ć hardware fault

37 DC drive I/O controller runĆtime board error

Ć hardware fault

38 UDC module generated a STOP ALL

39 UDC module interrupt allocation failed

3A Processor OS incompatible with UDC OS

Corrective action: correct the problem in application software. Try to reset by

cycling power and reĆloading configuration and application tasks. Replace the

Processor module. For error code 31, see JĆ3650; for error code 37, see JĆ3669.

For error code 17: If you define bits in a register that is also defined as a register,

neither the bits nor the register can be forced. For error code 38, examine the

error logs for all UDC tasks in the rack. Also, error code 38 can be caused by

enabling CCLK on more than one module in the rack. Verify that CCLK is enabled

on only one module. For error code 39, cycle power to the rack and reĆload the

configuration and application tasks.

BASIC STOP ALL Error Codes

The following error codes are caused by problems in BASIC tasks and cause all

tasks to stop.

40 Too many RETURNS from GOSUBs (or RETURN without GOSUB)

41 Illegal jump into a FOR loop

42 NEXT statement does not match current FOR

43 Invalid START EVERY statement

44 Invalid EVENT statement

45 STOP statement executed in application software

(causes a STOP ALL/CLEAR)

46 SET or WAIT attempted with no event definition

47 Task stack overflow

48 GOSUBs not balanced at END statement

49 Insufficient space for channel buffer

4A Attempted to execute undefined opcode

4B Attempted to execute nonĆexecutable opcode

4C Attempted to execute illegal opcode

4D RESTORE to nonĆDATA statement line number

4E Attempted to take square root of a negative number

4F Attempted to RESUME without being in an ON ERROR handler

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 59 60

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 57C435 Processor Module, AutoMax Manual de usuario Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 57C435 Processor Module, AutoMax