Rockwell-automation AADvance Controller System Build Manual de usuario descargar pdf (Pagina 99)

Document: 553632

(ICSTT-RM448_EN_P) Issue: 08:

4-19

10) Click OK and another error message is displayed.

11) Click OK then Cancel to Exit ControlFLASH.

12) Reboot the processor module by switching the power OFF then ON and hold in

the Fault Reset button as the module reboots until the Aux LED goes amber.

The processor module(s) will reboot into the Recovery Mode indicated by the

following LED states on the processor module.

Healthy Green (dependent on Module health)

Ready Amber

Run Amber

System Health Green (dependent on system health)

Force Amber

Aux Amber

Stage 2: Installing the ControlFLASH Firmware Kit for OS, FPGA, LSP and BUSP

Stage 2: Installing the ControlFLASH Firmware Kit for OS, FPGA, LSP and BUSPStage 2: Installing the ControlFLASH Firmware Kit for OS, FPGA, LSP and BUSP

Stage 2: Installing the ControlFLASH Firmware Kit for OS, FPGA, LSP and BUSP

This procedure describes how to upgrade the Processor Firmware for OS, FPGA, LSP

and BUSP.

The procedure that follows is basically the same as for stage 1.

1) Run the 354400_102_ControlFLASH.msi file.

2) Click NEXT.

3) Read and agree the License.

4) Click Browse to select the location of the installation or Next to choose the

default location.

5) Click Next to confirm the installation.

 ControlFLASH installs and shows the progress bar.

6) Click Yes I want to launch ControlFLASH, then click Close.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 129 130

Comentarios a estos manuales

Sin comentarios

Rockwell-automation AADvance Controller System Build Manual de usuario Pagina 99

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation AADvance Controller System Build