Rockwell-automation Current Input Module Manual de usuario descargar pdf (Pagina 18)

3Ć6

 #&  $ !"%

Use the following procedure to replace a module:

Step 1. Turn off power to the rack and all external devices.



          

         '

         

      

Step 2. Use a screwdriver to loosen the screws holding the DĆshell

connector to the module. Remove the DĆshell connector.

Step 3. Loosen the screws that hold the module in the rack.

Remove the module from the rack.

Step 4. Place the module in the antiĆstatic bag that it came in. Do

not touch the connectors on the back of the module. Place

the module in the cardboard shipping container.

Step 5. Take the new module out of the antiĆstatic bag. Do not

touch the connectors on the back of the module.

Step 6. Insert the module into the proper slot in the rack. Use a

screwdriver to secure the module to the rack.

Step 7. Attach the DĆshell connector to the module. Use a

screwdriver to secure the connector to the module.

Step 8. Turn on power to the rack and external devices.

Step 9. Connect the programming terminal to the system and run

the ReSource Software.

Stop all programs that may be running.

Configure the current input channels you are using by

following the procedure in section 4.2. You cannot monitor

until you have configured the channels. When you are

done configuring, read the channels' default values to

verify that the installation is correct. Refer to sections 4.1.1

to 4.1.17 for the default values.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 65 66

Sin comentarios

Rockwell-automation Current Input Module Manual de usuario Pagina 18