Rockwell-automation FactoryTalk Historian SE ProcessBook 3.2 User Guid Manual de usuario descargar pdf (Pagina 231)

100

101

6 ● Work with Symbols

●

213

Connection Points

Connection points on each symbol define where a Connector may connect.

Connection Points are visible in Build mode only and appear on symbols

as small x marks. When you select one with your cursor, it changes to an x

within a bounding circle.

ProcessBook symbols are originally built without Connection Points. A

Connection Point is created automatically when a Connector is dragged

into a symbol. This Point is created at the midpoint of the nearest edge of

the bounding rectangle of the symbol. The end of the Connector is moved

to the Connection Point. You may add Connection Points and move them

to specific locations.

A Connection Point can be used for either the start of the flow or the end of

a flow. The same Connection Point can be used for both. A flow can be bi-

directional.

If a second Connector is dragged over a symbol, it either moves to the

existing Connection Point or creates a new one.

For irregular figures, Connection Points are placed near the midpoint of the

side of the bounding rectangle of the figure, as shown in the illustration

below, rather than inside the figure itself. You can adjust the position of the

Connection Point to touch the actual figure.

Connector with Connection Point on the Bounding Rectangle.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 377 378

Comentarios a estos manuales

Sin comentarios

Rockwell-automation FactoryTalk Historian SE ProcessBook 3.2 User Guid Manual de usuario Pagina 231

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation FactoryTalk Historian SE ProcessBook 3.2 User Guid