Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual de usuario descargar pdf (Pagina 16)

16 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012

Chapter 1 Prepare the Distributed POINT I/O Module Hardware

Mount and Connect the 1734-AENT Ethernet Adapter

1. Position the adapter vertically in

front of the DIN rail and press

firmly onto the DIN rail until the

adapter locks into place.

2. To set the module’s IP address to a

valid number, set the module’s

thumbwheel switches to a number

between 001 and 254.

Numbers outside that range are

invalid. If the switches are set to a valid number at powerup, the module automatically uses

that number for its IP address.

3. Plug a 1585J-M4TBJM-1,

Ethernet cable (straight-through)

into a port on the

Stratix 6000 switch.

4. Plug the other end of the Ethernet

cable into the Ethernet port on the

1734-AENT POINT I/O

Ethernet adapter.

5. Remove the safety end cap.

IMPORTANT

In addition to the thumbwheel switches, there are other methods to assign an IP address to the POINT I/O

adapter, such as using the BOOTP/DHCP utility. For more information on how to set the IP address, see POINT

I/O Ethernet Adapter Installation Instructions, publication 1734-IN590.

Module

Status

Network Activity

Status

Network

Status

1734-AENT

PointBus

Status

Field

System

Power

Thumbwheel

Switches

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Sin comentarios

Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual de usuario Pagina 16