Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual de usuario descargar pdf (Pagina 30)

30 Rockwell Automation Publication IASIMP-QS027A-EN-P - February 2012

Chapter 2 Add the POINT I/O Ethernet Adapter and Digital Output Module to an RSLogix 5000 Project

Test the 1734-OB4E Output Module’s Light

1. Move the controller’s mode switch to the RUN position.

2. If not open, open the project’s Main Routine to find the ladder logic written earlier in

this chapter.

3. Select the PB and press Ctrl+T.

This toggles the state from 0 to

1 (off to on).

4. Verify that the light on the distributed digital output module turns on.

5. Press Ctrl+T to toggle the state

back to 0 (off).

6. Choose Go Offline.

Additional Resources

For a list of additional resources that might assist you when preparing the PowerFlex 40 drive

hardware, see page 11

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Rockwell-automation Logix5000 Control Systems: Connect POINT I/O Modul Manual de usuario Pagina 30