Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Manual de usuario descargar pdf (Pagina 19)

Rockwell Automation Publication 1441-UM001B-EN-P - September 2012 19

The Dynamix 2500 Data Collector Chapter 1

External Connections

The external hardware connections for communication and data collection are

located on the top panel of the Dynamix 2500 data collector.

Figure 2 - External Hardware Connections

Connector A and Connector B Inputs

The data collector has two signal inputs (LEMO connectors), connector A and

B. Headphone access is supported on Connectors A and B.

The measurement Input signal range is ±25 V maximum. Input over voltage

protection is AC ± 50 V peak, DC ± 50 V. The inputs are protected ±50 V AC

or DC sustained against high-voltage transients, but trigger range over-voltage

input levels must be avoided.

Voltage can be DC or AC coupled, while the third option, Accel (ICP) 24 V DC

@ 2.4mA, is available for direct connection of integrated circuit piezoelectric

transducers. These settings are specified in the Emonitor software.

See Setting Up Measurements on page 65

for more information.

POWER/USB/

TRIGGER

LASER

32144-M

Table 5 - Dynamix 2500 Data Collector Pin Assignments

Pin Connector A Connector B POWER/USB/TRIG

1 Audio Output Audio Output USBV

2 Channel X Channel Y USB+

3 Channel Z N/C USB-

4 Strobe Out Strobe Out DIGITAL GND

5 ANALOG GND ANALOG GND EXT-DC-IN

6 Channel Y N/C

± 25 V EXT-TRIG-IN

7 Channel R Channel Z +5V DC TACHO SUPPLY

TIP

In some circumstances you may find a reference to channel numbers

instead of X, Y, Z or R. Channel numbers can be cross referenced to

X= Ch(1), Y = Ch(2), Z= Ch(3), R = Ch(4).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 217 218

Sin comentarios

Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Manual de usuario Pagina 19