Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Manual de usuario descargar pdf (Pagina 26)

26 Rockwell Automation Publication 1441-UM001B-EN-P - September 2012

Chapter 1 The Dynamix 2500 Data Collector

Insert and Remove the Battery Pack

1. On the back of the instrument, use a flat head screwdriver to unlatch the

release screws.

Figure 7 - Rear View of the Dynamix 2500 Data Collector

2. Remove the battery cover.

3. Slide the battery pack to the left and lift it out.

WARNING: To make sure proper and safe Dynamix 2500 data collector

operation, only use the supplied battery pack.

WARNING: Only remove the battery in a nonhazardous environment:

• Avoid Battery Compartment Exposure.

• Do not open the battery compartment in a hazardous area, or in locations

where contact with water or other contaminants may occur.

WARNING: To minimize the risk of serious injury or damage do the

following:

• Do not expose the battery pack to temperatures in

excess of 60 °C (140 °F).

• Do not disassemble, incinerate, or short-circuit the battery pack.

• Danger of explosion if battery is incorrectly replaced.

• Replace the battery only with the same or equivalent type recommended

by the manufacturer.

• Dispose of used batteries according to the manufacturer’s instructions.

• Do not open battery compartment in a hazardous / explosive area.

Release screws to access

battery pack.

Once battery cover is removed,

slide the battery to the left and

lift out.

Reset switch

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 217 218

Sin comentarios

Rockwell-automation 1441-DYN25-Z Dynamix 2500 Data Collector Manual de usuario Pagina 26