Rockwell-automation 1734-SSI POINT I/O Synchronous Serial Interface Ab Manual de usuario descargar pdf (Pagina 46)

Publication 1734-UM007D-EN-P - December 2005

A-8 Configure Modules in RSLogix 5000 Software

2. From the Watch Position dialog, make entries for Automatic or

Manual mode, refering to the table and noting the following.

• For Automatic mode for Comparator Control 0 and 1, leave

the value as Not Active and complete the entries for

Comparator Value 0 and 1.

• For Manual mode, click a value for Comparator Control 0 and

1 and complete entries for Comparator Value 0 and 1, noting

that in the figure the value shows Up Direction for

Comparator Control 0.

3. Perform one of the following.

• Click OK to save changes and close the dialog.

• Click Cancel to return to default values.

• Click Apply to save changes you made on any of the dialogs

and continue to display the dialog, noting that you enable the

Apply button when you make changes to any of the dialogs.

• Click another tab at the top of dialog.

Comparator Control 0 and 1 Comparator Value 0 and 1

Automatic Manual Automatic Manual

Not Active Not Active

Up Direction

Down Direction

Both Directions

0…4294967295

with a default of 0

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53

Sin comentarios

Rockwell-automation 1734-SSI POINT I/O Synchronous Serial Interface Ab Manual de usuario Pagina 46