Rockwell-automation 1757-PIM ProcessLogix Pulse Input Module Installat Manual de usuario descargar pdf (Pagina 3)

ProcessLogix Pulse Input Module 3

Publication 1757-IN900A-US-P - February 2000

Installing the Module

Follow the procedure below to install the module.

Making Field Wiring Connections

Refer to the following pinout/wiring diagram to wire the module.

Figure 1 Pinouts and Wiring Example

ATTENTION

This input module permits the field-side input device (switch)

to be located on either the hot or neutral side of the source,

unless the module’s shorting bar has been installed. In this

case, the input device must be installed on the hot side of the

source.

This diagram illustrates how the eight transmitters will interface to the 36 Positions Terminal Block.

For instance, Transmitter 0 will be connected to Pins 1, 3 and 5 where:

•

Pin 1 is the Signal

•

Pin 3 is the Signal Common

•

Pin 5 is the Chassis Ground Shield Connection

The Output Channel 0 will connect to Pins 33 and 35 and Output Channel 1 will connect to Pins 34

and 36.

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

Rockwell-automation 1757-PIM ProcessLogix Pulse Input Module Installat Manual de usuario Pagina 3