Rockwell-automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User M Manual de usuario descargar pdf (Pagina 31)

Chapter 3

''"'%')''#"'%# #$%#&&#%

3-2

Connect the programming terminal to the COMM0 port—default

terminal port—of the main module. See Appendix C for cable and

connector information.

Figure 3.1

Personal Computer to Control Coprocessor Connection

 % #%' 

#"'%# #$%#&&#% 



%

#!!("'#"

"

The programming terminal that you select determines how you program

the control coprocessor.

If you use: You program using: See page:

 $%&#" #!$('%

' % &#')% " +#(% '*' '#% ,

"  '%!" , #!!", " "'% ,

Before you install and use the PCBridge software (1771-PCB), you must

have a working knowledge of DOS and its utilities, such as: DIR, COPY,

and TYPE. You must also be able to use a DOS text editor.

To install the PCBridge software and the library of functions you will use

for your programming, your personal computer must have at least:

640 Kbytes RAM

2 Mbytes online disk storage

DOS 4.0 or later

Included with the PCBridge software is:

a C cross-compiler, cross-assembler, and cross-linker

a C source-code debugger

Kermit—for sending/receiving data files and application programs

Internet-support software

A-B interface libraries

a text editor

Select the

Programming Interface

Install the Software on Your

Personal Computer

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 311 312

Sin comentarios

Rockwell-automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User M Manual de usuario Pagina 31