Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU Manual de usuario descargar pdf (Pagina 5)

Analog Input Module 5

Publication

17715.45 - July 1997

ATTENTION: Remove power from the 1771 I/O

chassis backplane and field wiring arm before

removing or installing an I/O module.

• Failure to remove power from the backplane or

wiring arm could cause module damage, degradation

of performance, or injury.

• Failure to remove power from the backplane could

cause injury or equipment damage due to possible

unexpected operation.

Place the module in the card guides on the top and bottom of the chassis that guide the module into position.

Important: Apply firm even pressure on the module to seat it into its

backplane connector.

Snap the chassis latch over the

top of the module to secure it.

Swing the chassis locking bar

down into place to secure the

modules. Make sure the locking

pins engage.

1771A1B, A2B, A3B1, A4B Series B I/O chassis1771A1B, A2B, A3B, A3B1, A4B I/O chassis

17643

wiring arm

install

remove

horizontal bar

Attach the wiring arm (1771WG) to the horizontal

bar at the bottom of the I/O chassis.

The wiring arm pivots upward and connects with

the module so you can install or remove the

module without disconnecting the wires.

1771WG

Install the Module and

Field Wiring Arm

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU Manual de usuario Pagina 5