
Isolated Analog Input Module4
3 *'!2'-, 8 !2- #0
The module has configuration jumpers for determining the input type
(voltage or current) for each input. The module is shipped with the
configuration jumpers positioned for voltage mode. You can
select either voltage or current for each input.
Key the Backplane
Connector
Place your module in any slot in the chassis
except the leftmost slot which is reserved for
processors or adapters.
ATTENTION: Observe the
following precautions when
inserting or removing keys:
• insert or remove keys with
your fingers
• make sure that key placement
is correct
Incorrect keying or the use of a
tool can result in damage to the
backplane connector and possible
system faults.
!
-1'2'-, 2&# )#7',% ,"1 ', 2&# !).*,# !-,,#!2-01 2- !-00#1.-," 2-
2&# )#7 1*-21 -, 2&# +-"3*#
*!# 2&# )#7',% ,"1
#25##, ,"
#25##, ,"
-3 !, !&,%# 2&# .-1'2'-, -$ 2# ,"1 '$
13 1#/3#,2 1712#+ "#1'%, ," 0#5'0',% +)#1
',1#02'-, -$ "'$$#0#,2 27.# -$ +-"3*# ,#!#1107
..#0
-,,#!2-0
8
!&11'1
Setting the Configuration
Jumpers
#+-4# 2&# $-30 1!0#51 1#!30',% 2&# 1'"# !-4#0 2-
2&# +-"3*# ," 0#+-4# 2&# !-4#01
1
#.-1'2'-, 2&# !-,$'%302'-, (3+.#01 11-!'2#" 5'2& #!& ',.32
!&,,#* !!-0"',% 2- 7-30 0#/3'0#+#,21
2
&# +-"3*# '1 1&'..#" 5'2& #!& !&,,#* 1#2 $-0 4-*2%# +-"# $
!300#,2 +-"# '1 "#1'0#" 7-3 +312 1#2 (3+.#0 -, 2&# $3,!2'-,*
,*-% *-!) -, 2&# +-"3*# -3 !, +'6 4-*2%# +-"# ,"
!300#,2 +-"# 1#22',%1
&,,#*
&,,#*
&,,#*
&,,#*
&,,#*
&,,#*
&,,#*
&,,#*
-,$'%302'-,
3+.#0
Voltage
Mode
Current
Mode
0-,2 4'#5
-$ +-"3*#
!'0!3'2 -0"
-.
Enlarged View
#.-1'2'-, 2&# !-4#0 ," 1#!30# 5'2& 2&# $-30
1!0#51 0#+-4#" ', 12#.
3
Comentarios a estos manuales