Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Manual de usuario descargar pdf (Pagina 32)

32 Rockwell Automation Publication 1788-UM058B-EN-P - September 2014

Chapter 2 Set Up in the Studio 5000 Logix Designer Application

Configure the Field Devices

This section describes how to configure one PV and multiple PVs for a slot.

Configure PV with Single Format

Each field device can have multiple PVs, each with a different format. In most

cases the default configuration correctly configures each PV, but if you add,

remove, or change PVs, make sure to change the format if needed. Table 2

shows

available PV format options.

Table 2 - Process Variable (PV) Format Options

To choose the PV format, follow these steps.

1. From the Device pull-down menu, choose the device that you want to

configure.

2. From the Slot pull-down menu, choose the type of PV.

3. From the format options pull-down menu, choose the format for the PV.

4. Click Ok to save the PV formats.

1 Byte 1 Byte with Status

2 Bytes 2 Bytes with Status

3 Byte 3 Byte with Status

4 Bytes 4 Bytes with Status

Real Real with Status

IMPORTANT

If you are not certain about the format of the PV, refer to the user manual of the

field device being used.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 75 76

Sin comentarios

Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Manual de usuario Pagina 32