Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Manual de usuario descargar pdf (Pagina 47)

Rockwell Automation Publication 1788-UM058B-EN-P - September 2014 47

Logix Assemblies Chapter 3

ParameterFault

This bit is set if there is a fault in the parameterization of the field device.

ParameterReq

This bit is set if the device has not received its parameterization.

FreezeMode

This bit is set if you enable Freeze mode in the parameterization of the field

device and a global control is sent to freeze the device PVs.

SyncMode

This bit is set if you enable Sync mode in the parameterization of the field device

and a global control is sent to synchronize the device PVs.

Wa t c h D o g

This bit is set if the watchdog is enabled in the parameterization of the field

device.

PAIdent

This is the identity number of the specific field device.

PVReal1…PVReal8

If you set a process variable to be a Real format, the data is displayed in this

section.

PVStatus1…PVStatus8

If you set a process variable to have a Status, the status value for the each PV is

displayed in this section.

See the user manual of the field device for the definition

of the PV status. In general, the status definitions are as

follows:

• Good = a value ≥ 0x80

• Uncertain = a value from 0x40…0x7F

• Bad = a value < 0x40 (for example, 0…0x3F)

PVInt1…PVInt8

If you set a process variable to be a 1-byte to 4-byte format, the data is displayed in

this image.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 75 76

Sin comentarios

Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Manual de usuario Pagina 47