Rockwell-automation 1788 NetLinx Media Checker Users Manual Manual de usuario descargar pdf (Pagina 35)

Setup Selections

1788-UM002A-US-P – April 2000

Setup Selections

In setup mode you can select cable characteristics and

customize the MediaChecker’s operation. Once changed,

these settings are stored and remain in the

MediaChecker even when it is turned off.

In setup mode you can do the following:

• Select a network protocol (Ethernet, ControlNet,

DeviceNet, DH+/RIO)

• Select a cable type

• Select a cable category

• Select a wire size

• Calibrate the MediaChecker to a specific cable

• Enable or display the beeper for “PASS” and “FAIL”

results

• Adjust the display contrast

To make a SETUP selection, do the following:

1. Press A.

2. Press E to step through the selections.

3. Press C or D to select the desired setup

condition.

4. Press A to exit the setup mode, or press E to

move to the next setup selection.

Setup selections that rarely need changing are under a

special “Power-up” menu. From the Power-up menu, you

can do the following:

• Select the display language

• Select length measurement units between feet (‘)

and meters (m)

• Select wire size units between AWG and millimeters

(mm)

• Set the noise filter for 50 Hz or 60 Hz

To make a Power-up setup selection, do the following:

1. With the MediaChecker OFF, press and hold A

while turning the rotary switch to TEST.

2. Press E to step through the selections.

3. Press C or D to select the desired setup

condition.

4. Press A to exit the setup mode, or press E to

move to the next setup selection.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Sin comentarios

Rockwell-automation 1788 NetLinx Media Checker Users Manual Manual de usuario Pagina 35