Rockwell-automation 2711P Creating Modbus Applications Manual de usuario descargar pdf (Pagina 17)

Publication 2711P-UM002B-EN-P - March 2007

Configuring KEPServer Drivers for Modbus 17

You should now see the following:

4. Click the button and OK to accept the new project as

the default.

Configure Drivers for

Modbus Protocols

This section shows how to configure KEPServer drivers that will allow

a PanelView Plus/PanelView Plus CE terminal to communicate on a

Modbus network.

Add a Channel

The first step in communicating to any device using the KEPServer

software is to create a channel. A channel describes the protocol and

driver properties used for communication. While a single channel can

be used to communicate to multiple devices, separate channels must

be defined for each unique driver to be used. Only one project

configuration file can run at a time, but it may contain multiple

channels and devices.

Step 1 - Add a New Channel

Click on the New Channel icon or right-click anywhere in the left

pane. This will bring up the new channel wizard.

Step 2 - Enter a Channel Name

Enter a unique name for the channel.

TIP

The KEPServer configuration is not archived with the

RSView Studio application backup (.apa) file. If you

need to reuse the project configuration file on

another computer, copy the .pfe file.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 91 92

Sin comentarios

Rockwell-automation 2711P Creating Modbus Applications Manual de usuario Pagina 17