Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Manual de usuario descargar pdf (Pagina 24)

24 ArmorStart EtherNet/IP Distributed Motor Controller Getting Started

Publication 280E-QS001B-EN-P – February 2011

Diagnostics

EtherNet/IP LED Status

Indication

EtherNet/IP LED status and diagnostics consists of four LEDs.

• Link Activity/Status LEDS

– Ethernet Link1 Activity/Status (Port 1) – LED Color: Bicolor

(Green/Yellow), refer to Table 3

– Ethernet Link2 Activity/Status (Port 2) – LED Color: Bicolor

(Green/Yellow), refer to Table 3

• “MOD” LED – Bicolor Red/Green represents the Ethernet Module

status, refer to Table 4

• “NET” LED – Bicolor Red/Green represents the Ethernet Network

status, refer to Table 6

Figure 35 – EtherNet/IP LED

Table 3 - Link 1 or Link 2 Port Activity/Status

Link 1 or 2 Status LED Description Recommended Action

Off No link established Verify network cabling, and correct, as needed.

Green Link established at 100 Mbps None

Flashing green Transmit or receive activity present at 100 Mbps None

Yellow Link established at 10 Mbps None

Flashing yellow Transmit or receive activity present at 10 Mbps None

Table 4 - Module Status Indicator

MOD Status LED Summary Requirement

Steady Off No power If no power is supplied to the device, the module status indicator shall be

steady off.

Steady Green Device operational If the device is operating correctly, the module status indicator shall be

steady green.

Flashing Green Standby If the device has not been configured, the module status indicator shall

be flashing green.

Flashing Red Minor fault If the device has detected a recoverable minor fault, the module status

indicator shall be flashing red.

Note: An incorrect or inconsistent configuration would be considered a

minor fault.

Steady Red Major fault If the device has detected a non-recoverable major fault, the module

status indicator shall be steady red, refer to Table 5.

Flashing Green/Red Self-test While the device is performing its power up testing, the module status

indicator shall be flashing green/red.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Sin comentarios

Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Manual de usuario Pagina 24