Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Manual de usuario descargar pdf (Pagina 35)

Publication 280E-QS001B-EN-P – February 2011

ArmorStart EtherNet/IP Distributed Motor Controller Getting Started 35

Control Module Removal

1. Disconnect power by going to the control module and turning OFF the

At-Motor disconnect and performing lockout-tagout per your company

policy.

2. Remove motor cable.

3. Loosen the four mounting screws.

4. Unplug the Control module from the base by pulling forward.

Installation of Control Module

5. Install control module.

6. Tighten four mounting screws.

7. Install motor cable.

Figure 39 – Control Module Replacement

ATTENTION: To avoid shock hazard, disconnect main power before

working on the controller, motor, or control devices.

Motor Cable

30 lb•in./

3.39 N•m

Note: DeviceNet™ base module is shown.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Sin comentarios

Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Manual de usuario Pagina 35