Rockwell-automation 5370-CUPK Color CVIM USER-PAK Option Manual de usuario Pagina 19

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 160
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 18
AB
3
Chapter
3 1
Installation
Contents
Chapter Objectives 31. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The Two USER-PAK Memory Cards 31. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing the USER-PAK Option 31. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using the Setup Card 33. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing Setup Mode with USER-PAK Installed 34. . . . . . . . . . . . . . . . .
This chapter describes how to install the USER-PAK option in the
Allen-Bradley 5370-CVIMC Color CVIM module, including the use of the
two memory cards on which the USER-PAK option software resides.
The USER-PAK option is provided on two separate memory cards. These
two cards are labeled Installation / Key card and Setup card respectively.
The purpose of each card is described below:
Installation / Key card This card serves two purposes: Use this card to
install the USER-PAK option into the Color CVIM module; use this card
also to access the setup mode in the case of lost passwords.
Important: Because this card can be used to override the Color CVIM
system security (see Chapter 4), it is suggested that this card be kept in a
secure place when not in use, and that access to this card be allowed only
to the appropriate authorized personnel.
Setup card Insert this card into the Archive Memory slot after the
USER-PAK option has been installed. This card must remain in the
Archive Memory slot during setup mode in order to access most of the
USER-PAK option capabilities.
This section describes how to install the USER-PAK option. You need only
install the USER-PAK option once; once installed, the USER-PAK option
remains installed for all subsequent powerups.
To install the USER-PAK option in your Color CVIM module:
Remove DC power from the Color CVIM module.
Insert the Installation / Key card into the Archive Memory slot on the
Color CVIM module. Insert the end with the metal strip facing right (see
Figure 3.1, page 3 2):
Chapter Objectives
The Two USER-PAK
Memory Cards
Installing the USER-PAK
Option
Vista de pagina 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 159 160

Comentarios a estos manuales

Sin comentarios