Rockwell-automation 5370-CUPK Color CVIM USER-PAK Option Manual de usuario descargar pdf (Pagina 25)

Chapter 4

Getting Started/Using the Security Levels

4 – 3

After USER-PAK installation, accessing the setup mode requires entry of a

password (unless security has been turned off – see “Setting Security

ON/OFF” later in this chapter).

Figure 4.1 Password entry keyboard

To enter the setup mode from run mode or standby mode (see Figure 4.1,

page 4 – 3):

• Pick the Setup box on the runtime display, which causes the password

keyboard to appear.

• Enter the appropriate password on the keyboard, and then pick Ret.

Listed below are further considerations for accessing the setup mode:

First Time Entry – Default Password: For entering the setup mode the

first time after installing the USER-PAK option, the default 3-character

password is A-B.

The initial entry will access the ADMINISTRATOR level of the setup mode.

Non-unique passwords: If the same password is assigned for two or more

levels, the password will access the highest level for that password.

Case-sensitivity: Password entry is case-sensitive. Use the “shift” arrow key

(lower left/right corners) to access the lower-case keyboard if necessary.

Password Display: The characters you select will appear as asterisks to the

right of Password: in the keyboard display.

Incorrect password: If you have not entered the password correctly, the

Status: line in the keyboard will display Incorrect Password:

Accessing the Setup Mode

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 159 160

Sin comentarios

Rockwell-automation 5370-CUPK Color CVIM USER-PAK Option Manual de usuario Pagina 25