Rockwell-automation 5720 DriveLogix System Manual de usuario descargar pdf (Pagina 82)

Publication 20D-UM002C-EN-P - November 2003

3-24 Placing and Configuring the Drive

Configuring the Controller’s Response to a Connection Failure

You can configure the drive module to generate a major fault in the controller

if the drive loses its connection to the controller.

If you do not configure the major fault to occur, you should monitor the drive

module status. If the drive loses its connection to the controller:

• Outputs remain in their last

• Inputs remain in their last state

• By default the drive will fault

Configure the drive to generate a controller major fault when the drive loses its

connection to the controller. Or, monitor the status of the drive module.

Check this box to configure the drive

module to generate a major fault if it

loses its connection to the controller

ATTENTION

If a drive loses its connection to the controller, the

controller and other I/O modules continue to operate

based on old data from the drive, and the drive can

continue to operate based on old data from the controller.

To avoid potential personal injury and damage to

machinery, make sure this does not create unsafe operation.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 262 263

Sin comentarios

Rockwell-automation 5720 DriveLogix System Manual de usuario Pagina 82