Rockwell-automation 6181P-xxxx Integrated Display Computers, Series A Manual de usuario descargar pdf (Pagina 21)

Publication 6181P-UM001G-EN-P - July 2008 21

Installation Chapter 2

6. Gradually tighten the clips, one at a time, around the bezel by

using the specified sequence.

The sequence begins with the center clips and continues to the

corner clips. Repeat this process at least three times until the

clips are hand-tight and the gasket is compressed uniformly

against the panel.

7. Tighten the mounting clips to a torque of 1.4 Nm (12 lb-in) by

using the sequence in step 6.

Do not overtighten.

Bench or Tabletop

Mounting

You can mount the 1500P or 1700P computer on a benchtop or

tabletop arm by using an optional adapter. The back of the computer

has four mounting points that are VESA 100 mm standard.

ATTENTION

Tighten the mounting clips to the specified torque to provide a

proper seal and prevent damage to the product. Rockwell

Automation assumes no responsibility for water or chemical

damage to the product or other equipment within the enclosure

because of improper installation.

1109

278

5

4

3

6

Torque Sequence

Cat. No. Description

6189V-MBA Bench/tabletop adapter for 1500P and 1700P

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Comentarios a estos manuales

Sin comentarios