Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function Manual de usuario descargar pdf (Pagina 83)

Rockwell Automation Publication 7000-UM201B-EN-P - June 2013 81

Appendix A

Hardware

Introduction

The HMI Interface Board module (Figure 79) consists of two circuit boards

sandwiched together. The base board is the PFNI (PowerFlex Network Interface

Board). It contains a socket into which the processor module (NetBurner)

connects into. This assembly is collectively referred to as the HMI Interface

Board. The HMI Interface Board (Part no. 80190-780-01-R) connects into the

DPM (Drive Processor Module) and becomes part of the drive control platform.

Figure 79 - HMI Interface Board Module

DIP Switch Settings

The DIP Switches (SW2), located on the PFNI board, perform the following

functions:

Switch 1: Swap Port

Port 0 is a diagnostic port which is available on either J3 as a standard USART

port or the USB Port. When this switch is OFF, the diagnostic port is on the J3

connection. The J3 connection is used exclusively for development and

diagnostic testing. Port 1 is a port to replace the functionality of the J4 Data port

on the DPM for PCs which do not have a serial port (for future use).

On Port 0 is on USB

Off Port 1 is on USB

Default OFF

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89 90

Sin comentarios

Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function Manual de usuario Pagina 83