Rockwell-automation AutoMax Enhanced Ladder Language Reference Manual Manual de usuario descargar pdf (Pagina 262)

12Ć10

 





Address Enter the address of the location where you want to write

data. If you enter an address, the slot input is ignored.

You must calculate the address using this information:

For a module that follows AutoMax conventions, choose

the base address based on the slot that the module

occupies and add an offset equal to the register * 2. (See

the Listing of Base Addresses for Each Slot in the

AutoMax Chassis)

For a nonĆReliance module, choose the address that

corresponds to the location of the information on the

module.

D simple

D constant

D element of an array

integer or double

integer (0240000 to

2FFFFFH)

Option Define the amount of I/O data you want to write by

entering an option number that corresponds to the

amount of data you want. See Defining the Amount of I/O

Data to Write.

integer (1Ć4)

 





This table lists the outputs for the IOW instruction and the variable type that each output

supports. To use ENO, connect it to a contact, coil, or Boolean input of another

instruction.





EN Use this output as the input to another instruction for

easily chaining multiple instructions. This output follows

the state of EN unless an error occurs.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 351 352

Sin comentarios

Rockwell-automation AutoMax Enhanced Ladder Language Reference Manual Manual de usuario Pagina 262