Rockwell-automation DeviceLogix System User Manual Manual de usuario descargar pdf (Pagina 189)

Publication RA-UM003B-EN-P - February 2010 189

RSNetWorx for DeviceNet Software and the DeviceLogix Editors Appendix B

To change a produced I/O assembly:

1. Click the current value of the Produced I/O Assembly.

The field turns into a drop-down list box.

2. Click the arrow to display the values.

3. Click the desired value.

4. Click Apply to save the new value without closing the window.

Or click OK to save the new value and to close the window.

For the layout of the Produced I/O Assembly for your chosen device,

refer to the Technical Data publication for that device.

IMPORTANT

Apply and download will be unsuccessful unless local logic is

disabled and the device is removed from the scanlist as

discussed in the Download To a Device section.

Input 7 Input 6 Input 5 Input 4 Input 3 Input 2 Input 1 Input 0

OW-D OW-C OW-B OW-A ISC-D ISC-C ISC-B ISC-A

OFLT 7 OFLT 6 OFLT 5 OFLT 4 OFLT 3 OFLT 2 OFLT 1 OFLT 0

OPWR Logic

Ena

OUT 7 OUT 6 OUT 5 OUT 4 OUT 3 OUT 2 OUT 1 OUT 0

PNB 7PNB 6PNB 5PNB 4PNB 3PNB 2PNB 1PNB 0

Standard MaXum Status and Diagnostic Bits

OW = Off-Wire; ISC = Input Short Circuit; OFLT = Output Fault; OPWR = Output Power

DeviceLogix Bits;

Logic Ena = DeviceLogix is Enabled. This can be used in the PLC to recognize that the

remote device is running a control program.

Out X = Status of Local Output Bit if it is under control of DeviceLogix

PNB X = Network Output Bits

(Where X = the number of the Output Bit or Network Output Bit.)

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 208 209

Sin comentarios

Rockwell-automation DeviceLogix System User Manual Manual de usuario Pagina 189