Rockwell-automation F1770-KFC(D)15 INSTL INSTR FLASH FIRMWARE KIT Manual de usuario descargar pdf (Pagina 2)

2 Flash Firmware Kit

Publication 1770-5.9 - May 1998

What You Must Provide You must provide the following two pieces of hardware for this

upgrade:

• A 386 (or better) IBM-compatible PC booted in DOS 6.22 or later.

You can run the flash upgrade tool from the disk or from your

PC’s hard drive.

• A serial cable to connect your computer’s COM port to the module,

such as:

•1784-CP10 (9 pin to 25 pin)

•1784-CP11 (25 pin to 25 pin)

Both cables require a female-to-female gender changer.

Prepare the Module The 1770-KFC and the 1770-KFCD firmware are comprised of a

boot section and an executive (main code) section. You must first

upgrade the executive section and then the boot section.

Install the Jumper

ATTENTION: Do not run this utility from

Microsoft

Windows 95

or Windows NT

™

in the

DOS window while operating Windows 95 or Windows

NT.

ATTENTION: Disconnect power before opening the

module. A qualified service technician must perform

the upgrade procedure.

ATTENTION: Circuit boards are highly sensitive to

electrostatic discharge (ESD). Handling a circuit board

without ESD protection can cause serious damage that

might not be apparent during installation or initial use.

To guard against ESD damage, before handling the

module, put on a grounding wrist-strap and touch a

grounding object to discharge any built-up static charge.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Rockwell-automation F1770-KFC(D)15 INSTL INSTR FLASH FIRMWARE KIT Manual de usuario Pagina 2