Rockwell-automation Logix5000 Control Systems: Connect a PowerFlex 70 Manual de usuario descargar pdf (Pagina 26)

26 Rockwell Automation Publication IASIMP-QS030A-EN-P - July 2012

Chapter 2 Create DeviceNet Network Software Files

Set the 1769-SDN Scanner Module’s Node Address

This quick start describes how to use a PowerFlex 70 drive in a CompactLogix 5370 L3 control

system over a DeviceNet network. The computer is connected to the controller via an

EtherNet/IP network, and the controller accesses the drive on the DeviceNet network via a

1769-SDN scanner module installed in a local expansion module slot.

To complete the steps described in this chapter, the scanner module uses the DeviceNet network

node address 0:

• If your scanner module’s node address is already set to 0, you can skip this section and move

to Create a DeviceNet Configuration File on page 29

• If your scanner module’s node address is not set to 0, use this section to learn how to change

it from its current value. For example purposes, the scanner module’s node number is 3

before it is changed.

1. Verify the controller’s mode switch

is in the PROG position.

2. Start RSNetWorx for

DeviceNet software.

IMPORTANT

The tasks described in this section require the use of the Node Commissioning tool in RSNetWorx for DeviceNet

software. If you are using RSLogix 5000 software, version 20 or later, as required with this quick start, the Node

Commissioning tool was an optional choice during the software installation.

If you did not install the Node Commissioning tool previously, do so now.

RUN

REM

PROG

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 53 54

Sin comentarios

Rockwell-automation Logix5000 Control Systems: Connect a PowerFlex 70 Manual de usuario Pagina 26