Rockwell-automation SB3000 Configuration and Programming Manual de usuario descargar pdf (Pagina 60)

3-42

SB3000 Drive Configuration and Programming

Parallel Power Module B Status Register (Continued) 220/1220

Phase W-Lower IOC B Bit 5

The Phase W-Lower B status bit is set if an

IOC or DSAT fault occurs in Power Module

B’s phase W, lower power device.

Hex Value: 0020H

Sug. Var. Name: W_LOB@

Access: Read only

UDC Error Code: N/A

LED: N/A

Intelligent Power Module B Bit 6

The Intelligent Power Module B bit is set to

indicate that a DSAT (shoot-through) fault

has occurred in Power Module B.

Hex Value: 0040H

Sug. Var. Name: IPUB@

Access: Read only

UDC Error Code: N/A

LED: N/A

Bits 0 - 5 of this register should be checked to identify the device in which the fault

occurred.

GDI Fault B Bit 7

The GDI Fault B bit is set if a fault is

detected in the power supply of Power

Module B’s Gate Driver Interface module.

Hex Value: 0080H

Sug. Var. Name: GDIB@

Access: Read only

UDC Error Code: N/A

LED: N/A

Charge Fault B Bit 8

The Charge Fault B bit is set if a charge bus

time-out fault occurs in Power Module B

(refer also to register 202/1202, bit 6).

Hex Value: 0100H

Sug. Var. Name: CHGB@

Access: Read only

UDC Error Code: N/A

LED: N/A

Over Temperature B Bit 12

The Over Temperature B bit is set if an over

temperature fault or warning occurs in

Power Module B.

Hex Value: 1000H

Sug. Var. Name: OTB@

Access: Read only

UDC Error Code: N/A

LED: N/A

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 121 122

Comentarios a estos manuales

Sin comentarios

Rockwell-automation SB3000 Configuration and Programming Manual de usuario Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation SB3000 Configuration and Programming