Rockwell-automation SD3000 Drive Configuration, Programming Manual de usuario descargar pdf (Pagina 2)

The information in the user’s manual is subject to change without notice.

ONLY QUALlFlED ELECTRICAL PERSONNEL FAMILIAR WITH THE CONSTRUCTION

OPERATION OF THIS EQUIPMENT AND THE HAZARDS INVOLVED SHOULD INSTALL, ADJUST,

OPERATE, OR SERVICE THIS EQUIPMENT. READ AND UNDERSTAND THIS MANUAL AND OTHER

APPLICABLE MANUALS IN THEIR ENTIRETY BEFORE PROCEEDING. FAILURE TO OBSERVE THIS

PRECAUTION COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.

WARNING

THE USER MUST PROVIDE AN EXTERNAL, HARDWIRED EMERGENCY STOP

CIRCUIT OUTSIDE OF

THE CONTROLLER CIRCUITRY THIS CIRCUIT MUST DISABLE THE SYSTEM IN CASE OF

IMPROPER OPERATION. UNCONTROLLED MACHINE OPERATION MAY RESULT IF THIS

PROCEDURE IS NOT FOLLOWED. FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN

BODILY INJURY

WARNING

ONLY QUALIFIED RELIANCE PERSONNEL OR OTHER TRAINED PERSONNEL WHO UNDERSTAND

THE POTENTIAL HAZARDS INVOLVED MAY MAKE MODIFICATIONS TO THE RACK

CONFIGURATION, VARIABLE CONFIGURATION, AND APPLICATION TASKS. ANY MODIFICATIONS

MAY RESULT IN UNCONTROLLED MACHINE OPERATION. FAILURE TO OBSERVE THESE

PRECAUTIONS COULD RESULT IN DAMAGE TO EQUIPMENT AND BODILY INJURY.

WARNING

REGISTERS AND BITS IN THE UDC MODULE THAT ARE DESCRIBED AS “READ ONLY” OR FOR

“SYSTEM USE ONLY” MUST NOT BE WRITTEN TO BY THE USER. WRITING TO THESE REGISTERS

AND BITS MAY RESULT IN IMPROPER SYSTEM OPERATION. FAILURE TO OBSERVE THIS

PRECAUTION COULD RESULT IN BODILY INJURY

CAUTION: Electronic motor overload protection must be provided for each motor in a Distributed Power

drive application to protect the motor against excessive heat caused by high currents. This protection can be

provided by either the THERMAL OVERLOAD software block or an external hardware device. Applications in

which a single power module is controlling multiple motors cannot use the THERMAL OVERLOAD software

block and must use an external hardware device or devices to provide this protection. Failure to observe this

precaution could result in damage to, or destruction of, the equipment.

EthernetTM is a trademark of Xerox Corporation.

WindowsTM

’

a trademark of Microsoft Corporation.

ReSourceTM

’

a trademark of Reliance Electric Company or its subsidiaries.

Reliance* and AutoMax@ are registered trademarks of Reliance Electric Company or its subsidiaries.

1 2 3 4 5 6 7 ... 117 118

Sin comentarios

Rockwell-automation SD3000 Drive Configuration, Programming Manual de usuario Pagina 2