Rockwell-automation T8082 Trusted Toolset Suite Manual de usuario descargar pdf (Pagina 24)

Trusted

Toolset Suite T8082

Issue 14 Feb 10 PD-T8082 24

2. Output Modules

This section defines the mapping between the output state and the front panel indicators for the

specific module. The mapping defines the required operation for all output channels. An LED mapping

entry is made using the syntax shown below.

state# = <OFF | RED | GREEN [+FLASH]>

f no entries are made in this section, the module will operate with the default LED mapping. The

example in Table 3 below shows defaults for the 8451 Digital Output Module, which are suitable for

outputs without line monitoring devices installed.

0 = Off – Not used

1 = Red – No field supply voltage

2 = Off – Output de-energised (off)

3 = Green – Line open circuit

4 = Green – Output energised (on)

5 = Red – Field short circuit

6 = Off – Not used

7 = Off – Not used

8- = Red –

Table 3 8451 Output Module LED Default Settings

Note: States 8 through 15 all represent channel fault states.

Input and Output Module LED templates are configured using the Module LED State Editor. On

creating an LED template, select ‘Module’ in the LED Config section. The Module LED State Editor is

described in section 2.3.7 below.

2. Zone Interface Modules

Trusted

8448 Zone Interface Modules can have each channel defined as an input or an output using

a Channel Template. In this case, one single LED definition for all channels is not appropriate. The

LED states for this module are configured using the Channel LED State Editor. On creating an LED

template, select ‘Channel’ in the LED Config section. The Channel LED State Editor is described in

section 2.3.8 below.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 81 82

Sin comentarios

Rockwell-automation T8082 Trusted Toolset Suite Manual de usuario Pagina 24