Rockwell-automation T8082 Trusted Toolset Suite Manual de usuario descargar pdf (Pagina 40)

Trusted

Toolset Suite T8082

Issue 14 Feb 10 PD-T8082 40

he user should enter the slot number appropriate to the ‘master’ Trusted

xpander Interface

Module in the Controller Chassis, i.e. 1, then select the OK button. This connects the Expander

Chassis to the ‘master’ Trusted

Expander Interface Module. If no Expander Interface Module has

been defined at this point, one will be created automatically at the referenced position.

It is also possible to connect expander chassis to a Trusted

Expander Interface Module by selecting

the Expander Interface Module with the left mouse button. The window shown in Figure 25 below is

displayed.

Figure 25 Expander Interface Parameters Window

To connect an expander chassis to a channel on the Expander Interface, left-click and drag the ‘chip’

icon in the Unconnected Chassis window to the appropriate channel in the Physical Connections

area. The channel will then show the number of the connected chassis. Repeat for the other

unconnected chassis. To disconnect a chassis, left click on the channel and drag the icon back to the

Unconnected Chassis window. Click OK when complete.

Note that the connected Expander Chassis are now marked by a light blue ‘lightning flash’. This

indicates that the Expander Chassis is connected.

The Chassis Connection window also shows the switch configuration necessary for each expander

chassis. Place the cursor on the left-hand edge of Expander Chassis again, then press the left-hand

button to cause the Chassis Connection window shown in Figure 26 below to be displayed again.

Figure 26 Chassis Connection Window

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 81 82

Sin comentarios

Rockwell-automation T8082 Trusted Toolset Suite Manual de usuario Pagina 40