Rockwell-automation 1395 Multi-Comm Hardware/Software Manual de usuario descargar pdf (Pagina 118)

Chapter 8

Reference

8–23

RIO Parameters The parameter definitions for the MCA board are dependent on the channel

configuration setup using DIP switches U5, U6, U14, and U15. When a

channel is setup for use on RIO then the parameter definitions in this

section will apply. Refer to the DIP switch settings to determine channel

setup. Parameter definitions for channels setup for DH+ are listed in the

next section.

Parameter 400 – [A>ChA RIO In 1]

Parameter 300 – [B>ChA RIO In 1]

Use: Channel A RIO Input word #1

Parameter Type: Fast Source

Program Terminal Units: None

Minimum Value:

Maximum Value:

Default Value: None

Description: This parameter is a fast source that contains the first word

or group of data from the PLC controller output image table. The data is

transferred to the Drive by the RIO scanner every rack scan. The value

can be used by the MCA board directly or by other Drive functions

through a configuration link. This parameter is displayed for 1/2, 3/4 and

full rack configuration.

Parameter 401 – [A>ChA RIO In 2]

Parameter 301 – [B>ChA RIO In 2]

Use: Channel A RIO Input word #2

Parameter Type: Fast Source

Program Terminal Units: None

Minimum Value:

Maximum Value:

Default Value: None

Description: This parameter is a fast source that contains the second

word or group of data from the PLC controller output image table. The

data is transferred to the Drive by the RIOscanner every rack scan. The

value can be used by the MCA board directly or by other Drive functions

through a configuration link. This parameter is displayed for 1/2, 3/4 and

full rack configuration.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 146 147

Sin comentarios

Rockwell-automation 1395 Multi-Comm Hardware/Software Manual de usuario Pagina 118