Rockwell-automation 1772-LV Mini-PLC - 2/15 Programmable Controller (S Manual de usuario descargar pdf (Pagina 104)

Chapter

81

Programming Fundamental Instructions

This chapter shows how to program the fundamental instructions.

In this chapter you will read how to:

Enter rungs using relay type instructions.

Insert an instruction into an existing rung.

Remove an instruction from an existing rung.

Edit an existing rung.

Power up your industrial terminal by turning the ON/OFF switch clockwise.

The switch is located to the right of the screen (Figure 8.1).

Figure 8.1

Industrial

erminal

10697I

After a short while, the following display will appear:

Figure 8.2 illustrates the screen’s display which you will see before you begin to

insert your program. Press the keys 11 to start programming.

NOTE: The processor mode select switch must be in the PROG keyswitch

position before you are able to insert your program.

Now you are able to insert your program. Proceed to section A.

Objectives

System Start Up

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 214 215

Sin comentarios

Rockwell-automation 1772-LV Mini-PLC - 2/15 Programmable Controller (S Manual de usuario Pagina 104