Rockwell Automation 22-WIM-N4S Manual de usuario Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
2-4 Installing the WIM
9. Establish wireless communication between the WIM and the Pocket
PC or computer. For this procedure, refer to the respective section in
Chapter 3 that corresponds to the drive software tool you are using:
Using Pocket DriveExplorer for Pocket PC
on page 3-2
Using DriveExplorer/DriveExplorer Lite on page 3-10
Using DriveExecutive on page 3-16
When communication is achieved, the WIM status LED will turn
solid blue.
Figure 2.4 Mounting NEMA 4 WIM onto Panel
The drive can remain powered when removing a WIM.
Remove the WIM from the remote-mounted HIM bezel.
0.68 N-m
(6.0 lb.-in.)
Removing the NEMA 1 WIM (22-WIM-N1)
!
ATTENTION: Risk of injury or equipment damage exists. If the HIM
bezel cable (for a bezel-mounted WIM) is disconnected from Port 2 on
the bottom of the drive, the drive may fault. Determine how the drive
will respond before disconnecting the cable.
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Comentarios a estos manuales

Sin comentarios