Rockwell-automation 160 RSI SERIAL COMM MODULE Manual de usuario descargar pdf (Pagina 33)

Chapter

Using the RS1 Module with a

Programmable Controller

This chapter provides an overview of the steps needed to use the RS1

Module with a MicroLogix 1000 (or other Allen-Bradley

programmable controllers). The programmable controller can send

control messages to the RS1 Module and receive status messages

back. The device also allows a ladder logic program to conﬁgure and

read parameters from the 160 Drive.

This chapter contains the following information:

• How to setup the RS1 Module with a programmable controller.

• A sample ladder logic program to control the 160 Drive.

• A description of reading parameters using the Message (MSG)

Command.

• A sample ladder logic program to read parameters.

The MicroLogix 1000 Programmable Controller was used with

RSLogix 500™ software for the examples shown in this chapter – the

concepts demonstrated apply to other programmable controllers as

well, including the SLC 500 and PLC-5.

Before continuing, the user should have read and understood:

• MicroLogic 1000 Programmable Controller User Manual,

Publication 1761-6.3 (or appropriate controller User Manual).

• SLC 500 and MicroLogix 1000 Instruction Set Reference Manual,

publication 1747-6.15.

Required Tools

The following tools will be needed to complete this chapter:

• 160 Drive equipped with an RS1 Communication Module.

• MicroLogix 1000 Programmable Controller.

Example Network

160 Drive with RS1

MicroLogix 1000

FAULT

READY

RS232

Serial Comm

COMM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 49 50

Sin comentarios

Rockwell-automation 160 RSI SERIAL COMM MODULE Manual de usuario Pagina 33