Rockwell-automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-P Manual de usuario descargar pdf (Pagina 15)

Rockwell Automation Publication 1732E-UM005A-EN-E - July 2012 7

Chapter

Install Your ArmorBlock Module

Overview

This chapter shows you how to install and wire the 1732E ArmorBlock Dual Port

4-Point EtherNet/IP Analog Input and Output modules. The only tools you

require are a flat or Phillips head screwdriver and drill. This chapter includes the

following topics:

Install the Module

To install the module:

• Set the network address

• Mount the module

• Connect the I/O, Network, and Auxiliary cables to the module.

Set the Network Address

The I/O block ships with the rotary switches set to 999 and DHCP enabled. To

change the network address, you can do one of the following:

• adjust the node address switches on the front of the module.

• use a Dynamic Host Configuration Protocol (DHCP) server, such as

Rockwell Automation BootP/DHCP.

• retrieve the IP address from nonvolatile memory.

The I/O block reads the switches first to determine if the switches are set to a

valid number. To set the network address:

1. Remove power.

2. Remove the switch dust caps.

3. Rotate the three (3) switches on the front of the module using a small

blade screwdriver.

4. Line up the small notch on the switch with the number setting you wish to

use.

Valid settings range from 001…254.

Topics Page

Install the Module 7

Set the Network Address 7

Mount the Module 9

Wire the Module 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 95 96

Sin comentarios

Rockwell-automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-P Manual de usuario Pagina 15