Rockwell-automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-P Manual de usuario descargar pdf (Pagina 45)

Rockwell Automation Publication 1732E-UM005A-EN-E - July 2012 37

Configure Your Analog Input and Output Modules with RSLogix 5000 Software Chapter 3

1. Choose from the options on the Limit Configuration tab.

2. After the channels are configured, do one of the following:

• Click Apply to store a change but stay on the dialog box to choose

another tab.

• Click OK to apply the change and close the dialog box.

• Click Cancel to close the dialog box without applying changes.

Limit Configuration tab

Field What to do Description

Channel Select apush button

to correspond to a

channel (0…3).

Refers to the channel being configured.

Click to configure.

Clamp Limits

High Clamp

Low Clamp

Type a high and low

clamp value that

limits the output

from the analog

module within this

range.

See Clamping/Limiting

on page 47 for more

information.

Disable All Alarms Click to check the

checkbox

Check the box to disable all alarms.

Important: When you disable all alarms, you

disable process, and channel diagnostic alarms (for

example, underrange and overrange). We

recommend that you disable only unused channels

so extraneous alarm bits are not set.

Latch Limit Alarms Click to check the

checkbox

Check the box to latch an alarm if the controller

data value exceeds the clamping limit.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 95 96

Sin comentarios

Rockwell-automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-P Manual de usuario Pagina 45