Rockwell-automation 1761-NET-DNI DeviceNet Interface (DNI) Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Publication 1761-UM005B-EN-P - October 2006
26 Installation and Wiring
Network Port Wiring
DeviceNet Network
To properly design your DeviceNet network, see DeviceNet Media
Design Installation Guide, publication DNET-UM072. This document
provides design guidelines concerning wiring practices, connectors,
grounding and power budgeting.
This publication is available from your Allen-Bradley distributor, or
from the Internet at www.literature.rockwell.com.
Port Identification
Cable Selection Guide
Port 2 of the DNI is an 8-pin mini-DIN RS-232 port that provides
connection to DF1 compatible RS-232 devices. The table below
describes the RS-232 compatible cables.
V–
CAN_L
SHIELD
CAN_H
V+
NET
MOD
NODE
DANGER
GND
TX/RX
DeviceNet Network
(Port 1) (Replacement
connector part no.
1761-RPL-0000)
RS-232 (Port 2)
Use this write-on
area to mark the
DeviceNet node
Address.
RS-232 Devices
DNI Connected to: Catalog Number Use Cable
MicroLogix (all series) 1761-CBL-AM00
1761-CBL-HM02
Mini DIN to Mini DIN
45cm (17.7 in)
2m (6.5 ft.)
SLC 5/03, SLC 5/04, or
SLC 5/05 Channel 0
1761-CBL-AP00
1761-CBL-PM02
Mini DIN to D-Shell
45cm (17.7 in)
2m (6.5 ft.)
PLC 5 1761-CBL-AP00
1761-CBL-PM02
Mini DIN to D-Shell
45cm (17.7 in)
2m (6.5 ft.)
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Comentarios a estos manuales

Sin comentarios