Rockwell-automation 1769-IF4FXOF2F Compact Combination Fast Analog I/O Manual de usuario descargar pdf (Pagina 25)

Publication 1769-UM019A-EN-P - October 2008 25

Installation and Wiring Chapter 2

Remove the Finger-safe

Terminal Block

When wiring field devices to the module, it is not necessary to remove

the terminal block. If you remove the terminal block, use the write-on

label on the side of the terminal block to identify the module slot

location and type. RTB position (for one-and-a-half size modules) can

be indicated by circling either the R for right side or L for left side.

Finger-safe Terminal Block

To remove the terminal block, loosen the upper and lower retaining

screws. The terminal block will back away from the module as you

remove the screws. When replacing the terminal block, torque the

retaining screws to 0.46 N•m (4.1 lb•in).

Wire the Finger-safe

Terminal Block

When wiring the terminal block, keep the finger-safe cover in place.

1. Loosen the terminal screws to be wired.

2. Begin wiring at the bottom of the terminal block and move up.

SLOT # ____

MODULE TYPE _____

R L

RoHS

Upper Retaining Screw

Lower Retaining Screw

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 93 94

Sin comentarios

Rockwell-automation 1769-IF4FXOF2F Compact Combination Fast Analog I/O Manual de usuario Pagina 25