Rockwell-automation 1784-PM16SE SoftLogix Motion Card Setup and Config Manual de usuario descargar pdf (Pagina 181)

100

101

173 Publication 1784-UM003A-EN-P – June 2003

Chapter

Creating & Configuring Your Coordinate

System Tag

Introduction

The Coordinate System tag is used to set the attribute values to be used by the

Multi-Axis Coordinated Motion instructions in your motion applications. The

Coordinate System tag must exist before you can run any of the Multi-Axis

Coordinated Motion instructions. This is where you introduce the

COORDINATE_SYSTEM data type, associate the Coordinate System to a

Motion Group, associate the axes to the Coordinate System, set the dimension,

and define the values later used by the operands of the Multi-Axis Motion

Instructions. The values for Coordination Units, Maximum Speed, Maximum

Acceleration, Maximum Deceleration, Actual Position Tolerance, and

Command Position Tolerance are all defined by the information included

when the Coordinate System tag is configured. This chapter describes how to

name, configure, and edit your Coordinate System tag.

Creating a Coordinate

System

Creating a coordinate system adds it to your application. There are four ways

in which you can initiate the creation of a coordinate system. The first way is to

go to the File pull-down menu, select New Component, and then select Tag.

Figure 7.1 File Menu to New Component to Tag

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 450 451

Comentarios a estos manuales

Sin comentarios

Rockwell-automation 1784-PM16SE SoftLogix Motion Card Setup and Config Manual de usuario Pagina 181

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Rockwell-automation 1784-PM16SE SoftLogix Motion Card Setup and Config