Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Manual de usuario descargar pdf (Pagina 34)

2–12 Installing the Software

Publication 2706-6.2

5. Assuming you have installed the Ethernet Board drivers in the

directory C:\PCTCP (the default), be sure the following lines

appear in your CONFIG.SYS file.

DEVICE=C:\PCTCP\PROTMAN.DOS /I:C:\PCTCP

DEVICE=C:\PCTCP\SMC8000.DOS

DEVICE=C:\PCTCP\DIS_PKT.GUP

6. Save the file. If you are using the DOS text editor, type:

[ALT]FXY

7. Open the AUTOEXEC.BAT file with any ASCII text editor. If

you use the DOS text editor, type:

EDIT C:\AUTOEXEC.BAT↵

Your AUTOEXEC.BAT file contents appears in the editing

window.

8. Move the cursor to the end of the file.

9. The following lines should appear in the AUTOEXEC.BAT file.

If they are not there, add them now.

SET PCTCP=C:\PCTCP\PCTCP.INI

C:\PCTCP\NETBIND.COM

C:\PCTCP\ETHDRV.EXE

For additional information regarding installation of your PC/TCP

software, refer to the section on installing an NDIS driver in the

PC/TCP Software Installation Guide.

Restart Your PC

When installation is complete, remove the installation diskette from

the 3

inch micro drive and store all installation software in a safe

place. Finally, restart your PC to activate your changes to the

CONFIG.SYS and AUTOEXEC.BAT files.

Configure Your PLC

Use Allen-Bradley’s 6200 Series PLC-5 programming software or

the EIBOOT utility to set the PLC’s IP address. Refer to the

documentation that came with your PLC for additional configuration

information.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 148 149

Sin comentarios

Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Manual de usuario Pagina 34