Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Manual de usuario descargar pdf (Pagina 35)

2–13Installing the Software

Publication 2706-6.2

If you have installed the Offline Programming Software without

PassThrough processing, your computer will return to the DOS

prompt, C:\DL40>. If you have installed PassThrough processing,

your computer returns to the directory it displayed when you began

the PassThrough processing installation.

If you do not return to the C:\DL40> directory, change directories by

typing:

CD C:\DL40↵

You may then start the the Offline Programming Software program

by typing:

DL40↵

The communication port settings on your computer and the DL40

must be the same in order to communicate.

• the port usage on the RS-485 port must be set to PRGMR to

perform message file transfers via the RS-485 port.

• the DL40 RS-232 port will always communicate with the DL40

Offline Programming Software regardless of the port

configuration.

• set your computer’s serial communication port to the following:

– baud rate 9600

– data bits 8

– parity none

– handshaking none

• Use the [SELECT] and [ENTER] push buttons on the front panel

of the DL40 to select SET RS232PORT?– PGMR/PRNTER

SETUP or SET RS-485 PORT?–PRGMR and set the parameters

to match the setting of your computer’s serial communication

port.

Note: Select Enable DIP switch (SW2-9) must be ON.

• You can also change the settings of the DL40’s serial ports with

the [CTRL][R] command using the DL40’s Onboard Editor and

an IBM compatible keyboard connected to the rear keyboard port

of the DL40 display.

Starting the Program

Establishing Initial

Non–networked

Communications

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 148 149

Sin comentarios

Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Manual de usuario Pagina 35